• The skirt should cover, at minimum, all visible acrylic.
• The strap should be measured from the bottom of the foam to the top of the safety clip.
Measuring the Radius:
The most efficient way to measure your radius is to use a carpenters Square. Place the carpenters square against the acrylic on at the corner of your hot tub. The measurement where the rounding of the corner stops, where the acrylic hits the carpenters square, will be your radius.
Take measurements from the outside of the acrylic, do not measure the inside of the hot tub as this will make your hot tub cover too small. Remember that the “A” side has the hinge on it. The “C” measurement is your radius.
~ if your hot tub corners are rounded please refer to our radius measuring guide.
Take measurements from the outside of the acrylic, do not measure the inside Of the hot tub as this will make your hot tub cover too small. Remember that the “A” Side has the hinge on it.
Take all measurements from the outside of the acrylic . The “C” measurement should be taken from edge to edge of the cut corners. Remember that the“A” side has the hinge on it.
~ if your corners are rounded please refer to our radius measuring guide.
Take all measurements from the outside of the acrylic . The “C” measurements should be taken from edge to edge of the cut corners. Remember that the “A” side has the hinge on it. Do not stop any measurements for the “A” or “B” lengths at the cut corner, the “C” measurement will give us that dimension.
~ if your corners are rounded please refer to our radius measuring guide.
You will only need one measurement that should be taken from one edge of the acrylic to opposite edge of acrylic.
Take all measurements from the outside of the acrylic . The “C” measurement should be taken from edge to edge of the cut corners. Remember that the “A” side has the hinge on it. Do not stop any measurements for the “A” or “B” lengths at the cut corner, the “C” measurement will give us this dimension.
~ if your corners are rounded please refer to our radius measuring guide.
Take all measurements from the outside of the acrylic . The “C” measurement should be taken from edge to edge of the cut corners. Remember that the “A” side has the hinge on it. Do not stop any measurements for the “A” or “B” lengths at the cut corner, the "C" measurement will give us this dimension.
~ if your corners are rounded please refer to our radius measuring guide.
